TÜV-certification!
The following guidelines are to be considered:
The lateral ends tail of a roof spoiler with gap must inward on the exterior surface of the vehicle course-bent to be, in order to limit the danger of getting stuck to a minimum.
The opening between spoiler end and his environment may amount to at 20 mm.
See sketch in layout 1a:
A rear/roof spoiler with gap may exceed the surrounding body structure in no place in the height at its front edge (based on the highest profile) around more as 100 mm and not have any more than 50 mm of increased height (measured perpendicularly in each case to the roadway).
The gap height in the closest place may not exceed 60 mm over the entire width of vehicle measured.
See sketch in layout 1b:
If they do not correspond at that requirements, then they have to be laterally closed and have not to be allowed over the frontal projection of the vehicle outline, as well as over the vehicle length to the rear to exceed. The edges directed outward must have a radius of the threat of exhibit at least 5 mm.
The spoiler is to be fastened in addition on the original vehicle binding.
Material Fiberglass
Breadth: 138 cm
The following guidelines are to be considered:
The lateral ends tail of a roof spoiler with gap must inward on the exterior surface of the vehicle course-bent to be, in order to limit the danger of getting stuck to a minimum.
The opening between spoiler end and his environment may amount to at 20 mm.
See sketch in layout 1a:
A rear/roof spoiler with gap may exceed the surrounding body structure in no place in the height at its front edge (based on the highest profile) around more as 100 mm and not have any more than 50 mm of increased height (measured perpendicularly in each case to the roadway).
The gap height in the closest place may not exceed 60 mm over the entire width of vehicle measured.
See sketch in layout 1b:
If they do not correspond at that requirements, then they have to be laterally closed and have not to be allowed over the frontal projection of the vehicle outline, as well as over the vehicle length to the rear to exceed. The edges directed outward must have a radius of the threat of exhibit at least 5 mm.
The spoiler is to be fastened in addition on the original vehicle binding.
Material Fiberglass
Breadth: 138 cm
This Product was added to our catalogue on Wednesday 14 October, 2009.
- Rear wing "US-LOOK" 138 with brake light bei Delicious bookmarken
- Mister Wong
- Rear wing "US-LOOK" 138 with brake light bei Digg bookmarken
- Rear wing "US-LOOK" 138 with brake light bei Stumble Upon bookmarken
- Rear wing "US-LOOK" 138 with brake light bei Technorati bookmarken
- Rear wing "US-LOOK" 138 with brake light bei MySpace bookmarken
- Rear wing "US-LOOK" 138 with brake light bei Facebook bookmarken
- Rear wing "US-LOOK" 138 with brake light bei Twitter bookmarken
